Hui Yue automatic dispenser troubleshooting methods

Longgang District, Shenzhen Hui Yue of mechanical parts of the business

Product Categories

Friendly Links

home > Supply > Hui Yue automatic dispenser troubleshooting methods

Hui Yue automatic dispenser troubleshooting methods

Information Name:	Hui Yue automatic dispenser troubleshooting methods
Published:	2014-11-18
Validity:	30
Specifications:	Hai Yue X-330
Quantity:	100.00
Price Description:
Detailed Product Description：	Hai Yue X-330 (Shenzhen Hui Yue Machinery Co., Ltd.), also known as automatic dispenser automatic injector machine troubleshooting This automatic injector fuel supply system and the machine is a combination of compressed air systems, so the quality of wind pumps pressure is stable or not, this device plays an important role. Using imported oil pump oil pump, after years of experience, to ensure good quality oil pump. Another factory air pressure system, often due to the use of other equipment in the factory, and produce uneven size of the gas pressure, leading injection machine running. First, check whether the normal operation of the injection machine steps: 1. Check the power outlet voltage power supply is consistent with Sprayer (AC220V / 50HZ)? 2. Check the fuse is blown? Replace the fuse of the same type; 3, check air intake pipe is connected well? Pressure is normal? 4. Check the "manual / automatic - when the control switch" to the oil cycle controller setting meets operational needs? Are rotated to set the time in the injection? 5, check whether the contact switch contact opening action of the sprocket do? 6. Check for oil control and automatic switching operation is normal? 7. Check the fuel injector operation is consistent with the instructions? 8. Check starvation indicating whether bright? Replenish the lubricant to the appropriate location. Second, the operation of transparent tubing injection machine without oil discharge: 1, first the "fog Adjust" button at the turn a small amount of wind to have air blowing, but was unable to successfully launch the oil situation, so this action runs to transparent tubing lubricating oil outflow; 2, then the "fog adjust" button from right to left ajar gradually, to lubricating oil can be discharged smoothly. Third, there is the case of drip injection frame: 1, when the injection machine during injection, only to hear the voice of the switch may be no pressure or less pressure compressed air, causing the lubricant dripping beneath the track; 2, in addition due to vibration or external causes conveyor pipe joints off, tubing outside the oil directly onto the track or on the floor, re-connect fitting or adjusting the mounting position; 3, due to contact with the injector position switch can not fit, the contact Switch back to front or adjusted to best position the injector. Fourth, the conveyor chain has drip phenomenon: the cause of many of the chain drip (oven temperature is too high, quality lubricants, spray compressed air instability, etc.), if the injection machine are several aspects to consider. 1, to reduce the number of injection machine of injection: oven at a temperature of 200 degrees or more, we recommend 24 hours three times, the chain runs a cycle; oven at a temperature of 150-200 degrees, the proposed 24 hours twice a chain to run a cycle ; oven at a temperature of 150 degrees issued the recommended 24 hours once the chain is running a cycle; 2, if the conveyor is running slower, resulting in a time-contact switch start-up time will be longer, than the amount originally budgeted injection further more, please adjust between 0.2-0.5 seconds.

Admin>>>
You are the 12339 visitor
Copyright © GuangDong ICP No. 10089450, Longgang District, Shenzhen Hui Yue of mechanical parts of the business All rights reserved.
Technical support: ShenZhen AllWays Technology Development Co., Ltd.
AllSources Network's Disclaimer: The legitimacy of the enterprise information does not undertake any guarantee responsibility